Forum Index
Jeep Horizons HomeLinksJeep Horizons Tech Write-upsJeep newsLand useContact

 Watched TopicsWatched Topics   FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Window Regulator


 
Post new topic   Reply to topic     Forum Index -> Cherokee Forum
View previous topic :: View next topic  
Author Message
GREATONES96
Member


Joined: 28 Jul 2005
Location: ARIZONA

PostPosted: Sat Mar 25, 2006 10:59 am    Post subject: Window Regulator Reply with quote

My right rear regulator broke and i noticed it is all one piece and i tried to get it out and cannot, Is there a trick to this or what? Embarassed Sorry 1997 xj
Back to top
View user's profile Send private message Visit poster's website
Renegadestang
Member


Joined: 07 May 2005
Location: Marietta, GA

PostPosted: Sat Mar 25, 2006 7:03 pm    Post subject: Reply with quote

My driver's side broke on my '98. Tried to figure out what happened and ended up bending the rod for the door lock. I ended up sucking it up and taking it to the stealership. They replaced the entire regulator and straightened the rod for around $215.
_________________
1998 Jeep Cherokee Sport: 4.0L, AW4, 235/75 Wild Spirit's

1981 Jeep CJ-7 Renegade: 307-4V SBC, SR-4 4-spd., 31x10.5 Wild Spirit's

1966 Ford Mustang: 289-4V, C4 Auto.
Back to top
View user's profile Send private message AIM Address MSN Messenger
majikxms
Moderator
Moderator


Joined: 18 Feb 2004

PostPosted: Sun Mar 26, 2006 2:01 am    Post subject: Reply with quote

First take a look on the Tech Page and read the write-up about XJ Window Regulator Repair (it's under the Electrical Section). It's for the front door, but the theory is the same.

Now that you're ready read these:

REAR DOOR WINDOW REGULATOR
REMOVAL
(1) Remove the door trim panel.
(2) Remove the waterdam.
(3) Remove the bolt attaching the window glass to
the regulator and support the glass.
(4) Remove the lower bolts attaching the regulator
to the inner door panel.
(5) Remove the nuts attaching the regulator motor
to the inner door panel, if equipped.
(6) Loosen the upper bolt that attaches the regulator
to the inner door panel.
(7) Disconnect the wire harness connector from the
regulator drive motor, if equipped.
(Cool Remove the regulator and drive motor, if
equipped.

INSTALLATION
(1) Position window regulator and, if equipped,
drive motor within the door panels.
(2) Install the fasteners attaching the regulator to
the door inner panel.
(3) Connect the regulator wire harness connector.
(4) Position the window glass at the regulator and
install the retainer, bushing and bolt.
(5) Install the waterdam.
(6) Install the trim panel.
Back to top
View user's profile Send private message
GREATONES96
Member


Joined: 28 Jul 2005
Location: ARIZONA

PostPosted: Mon Apr 03, 2006 4:26 am    Post subject: Reply with quote

Thank you for your guys help, Im gonna get it done this weekend.
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic     Forum Index -> Cherokee Forum All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Visit links4jeeps.com for write-ups, forums and clubs




Jeep®, Wrangler, Cherokee, Liberty and Grand Cherokee are copyrighted and trademarked to Chrysler LLC.
jeephorizons.com is not in any way associated with or endorsed by the Chrysler LLC.
All other content is copyright Jeep Horizons 2004-2008.
Tech write-ups Links Discussion board Land use News Site Map Terms of Use

Powered by phpBB © 2001, 2005 phpBB Group