Forum Index
Jeep Horizons HomeLinksJeep Horizons Tech Write-upsJeep newsLand useContact

 Watched TopicsWatched Topics   FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

89 wrangler yj stuck in 4th gear


 
Post new topic   Reply to topic     Forum Index -> YJ Forum
View previous topic :: View next topic  
Author Message
MonkeyHouse
Member


Joined: 21 Sep 2009

PostPosted: Mon Sep 21, 2009 7:54 am    Post subject: 89 wrangler yj stuck in 4th gear Reply with quote

I recently got an 89 Wrangler YJ(4.2L, 6 cylinder). When I got it it didn't start. Whoever had it previously had left just about everything disconnected. I went over it and cleaned up connections, re-connected everything I found disconnected and it still wouldn;'t start. I then noticed a ground was sparking when I tried to turn it over, there was a loose ground at the alternator. After I tightened this up and set the timing, it started. It drove pretty well, but most of the fluid levels were low. I topped off the levels and took it out for a spin. I noticed that I had to push the clutch to the floor to change gears. It still seemed to have trouble changing gears. Then while I was out, I couldn't get it out of second gear. I got it back home and checked the master cylinder, which appeared to be dry. Once I topped that off, I was able to change gears easily. I went to move it friday and put it in forth gear mistakenly instead of reverse. Now, I cannot get it out of fourth gear. The pedal feels fine and if I push the pedal in it will start just fine and doesn't move or act like it's in gear, acts as it should when you have the clutch pushed in. So, I'm not sure if this is a clutch issue, a transmission issue or a problem with the linkage. And why did the problem clear when I added fluid to the master cylinder and then lock into fourth gear? I also noticed that the bleeding valve moves in and out like 3 or 4 inches?? Is that normal? Is there any type of cover that is supposed to hold it in place? Any ideas where the problem is or what I should look at?
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic     Forum Index -> YJ Forum All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Visit links4jeeps.com for write-ups, forums and clubs




Jeep®, Wrangler, Cherokee, Liberty and Grand Cherokee are copyrighted and trademarked to Chrysler LLC.
jeephorizons.com is not in any way associated with or endorsed by the Chrysler LLC.
All other content is copyright Jeep Horizons 2004-2008.
Tech write-ups Links Discussion board Land use News Site Map Terms of Use

Powered by phpBB © 2001, 2005 phpBB Group