jeep xj 2.4l with auto 904

[billyji]

I have heard the 2.4l jeep (xj) with an auto is the same bolt pattern as the chevy/buick v6 97/98.also the spline counts are the same and you can put a dana 300 on that auto 904. does anyone have any knowledge on this or should i say more specifics....
Thanks
Mike G

where this is leading is a suprechrged v6 out of a riviera to a 904 to dana 300
_________________
sawzall solves all

++++++ Sponsor of http://www.getbent4x4.com dont miss all the action ++++++


=== Pro-Tools Bender Dealer ===

http://www.mikegreen4x4.com

http://www.blacksheep4x4.com

[Code3TJ]

Do you mean the 2.5L? There's just not much love for us 4bangers - I haven't heard of a lot of trannies that are compatible with that engine other than the NV4500. I also heard somewhere or other that you can use a bellhousing from a Chevy S-10 or Camero 2.8L V6 to mate an SM420. Actually, here's a link for a swap but it's on a YJ. Not real sure about an auto tranny. Anybody else?
_________________
Nothing to see here.

[billyji]

must be the 2.5 then
i found this
The 3800 supercharged front drive buicks have the 60 degree bellousing pattern. So you can easily go with a 904 or Th700 tranny for an auto, and quite a few manuals
in this thread
http://www.pirate4x4.com/forum/showthread.php?s=&threadid=203553&highlight=supercharged+v6

getting somewhere. thanks for the help...

Mike g
_________________
sawzall solves all

++++++ Sponsor of http://www.getbent4x4.com dont miss all the action ++++++


=== Pro-Tools Bender Dealer ===

http://www.mikegreen4x4.com

http://www.blacksheep4x4.com