Forum Index
Jeep Horizons HomeLinksJeep Horizons Tech Write-upsJeep newsLand useContact

 Watched TopicsWatched Topics   FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

HELP!!! Brake job on my own but I can't remove the rotors


 
Post new topic   Reply to topic     Forum Index -> Grand Cherokee Forum
View previous topic :: View next topic  
Author Message
markk100
Member


Joined: 17 May 2005

PostPosted: Tue May 17, 2005 3:45 pm    Post subject: HELP!!! Brake job on my own but I can't remove the rotors Reply with quote

Just trying to change the back two disc brakes on my 2000 with 4 wheel discs and I can't get the rotors off. Wheels and calipers are off, but can't get any farther... Any help is appreciated.
Back to top
View user's profile Send private message Send e-mail Yahoo Messenger
Jeep Iceland
Member


Joined: 12 Nov 2004
Location: Iceland

PostPosted: Tue May 17, 2005 4:06 pm    Post subject: Reply with quote

Remove the clips that hold the rotor position (on the bolts where the lug nuts screw on) Then you have to hit the rotor with a hammer here and there until you can pull it off.
[img][/img]
Hit with hammer where the arrows point at
[img][/img]
_________________
F.D
1996 Limited 5.2
http://www.cardomain.com/id/461ponchos96jeep
1976 Trans Am
http://www.cardomain.com/memberpage/531601
Back to top
View user's profile Send private message Visit poster's website
Jeep Iceland
Member


Joined: 12 Nov 2004
Location: Iceland

PostPosted: Tue May 17, 2005 4:09 pm    Post subject: Reply with quote

oh just make sure the parking brake is not engaged Rolling Eyes Mr. Green
This is from a 1996 GC but should be pretty much the same
_________________
F.D
1996 Limited 5.2
http://www.cardomain.com/id/461ponchos96jeep
1976 Trans Am
http://www.cardomain.com/memberpage/531601
Back to top
View user's profile Send private message Visit poster's website
mdawg318
Member


Joined: 31 May 2005
Location: Bel Air, Maryland

PostPosted: Tue May 31, 2005 11:52 am    Post subject: Reply with quote

i am assuming you are finished but they may be rusted on - just rent or buy a set of 6" or larger three prong pullers. they will pop off in a jiffy
Back to top
View user's profile Send private message Visit poster's website AIM Address
Display posts from previous:   
Post new topic   Reply to topic     Forum Index -> Grand Cherokee Forum All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Visit links4jeeps.com for write-ups, forums and clubs




Jeep®, Wrangler, Cherokee, Liberty and Grand Cherokee are copyrighted and trademarked to Chrysler LLC.
jeephorizons.com is not in any way associated with or endorsed by the Chrysler LLC.
All other content is copyright Jeep Horizons 2004-2008.
Tech write-ups Links Discussion board Land use News Site Map Terms of Use

Powered by phpBB © 2001, 2005 phpBB Group